top of page
Usine Beauceville 2_edited_edited.jpg

BUILDING PRODUCTS & ACCESSORIES

Usine Beauceville 2_edited_edited.jpg

 2" - 2 1/2" REBAR SPACER

3" - 3 1/2" REBAR SPACER

( 6" - 6 1/2" ) &  (7" - 7 1/2")

REBAR SPACERS

2" TIE BEAM & COLUMN

REBAR SPACERS

The 2" - 2 1/2" rebar spacers are a much more affordable method of holding rebar at the correct distance from the bottom of concrete forms. This replaces concrete blocks traditionally used to do the same purpose. This is most commonly used in 4" thick slabs

 ( 3" - 3 1/2" ) rebar spacers are a much more affordable method of holding rebar at the correct distance from the bottom of concrete forms. This replaces concrete blocks traditionally used to do the same purpose. This is most commonly used in 6" thick slabs

 ( 6" - 6 1/2" ) & ( 7" - 7 1/2" ) rebar spacers are designed to hold the top layer rebar mat. designed without the bottom ring so that you can install them on top of a bottom rebar mat without getting jammed. This is most commonly used in 10" - 12" thick slabs or footers

DESIGNED TO BE MUCH FASTER TO INSTALL COMPAIRED TO TRADITIONAL BOLSTER RUNNERS - WHICH REQUIRED CUTTING LENGTHS OF BOLSTER RUNNER AND TYING TO COLUMN WITH MINIMUM 2-3 BARTIES. THESE SPACERS CLIP RIGHT ON FOR IMMEDIATE SPACING FROM FORMS AND REQUIRES NO CUTTING. ALSO MUCH MORE COST EFFECTIVE.

NON CORROSIVE rebar tying wire for use with GFRP rebar and corrosive enviroments like coastal projects, seawalls, car washes, and ultimate protection from the elements.

standard rebar tying wire used for tying rebar.

galvanized rebar tying wire

steel rebar tying wire

Rebar safety caps

REBAR OSHA approved safety covers protect workers from falling onto rebar and saves the contractor from liability. The safety covers also make your jobsite look more professional and leaves a good impression

bottom of page